Installation

 

 

 

 

 

Installing finepanels is really quick and easy...

   
1

If possible start with a *whole panel and apply a zig-zag bead or blobs of panel glue to the rear face

2 new

Press panel firmly in position and pin, brad or screw the leading edge
to hold it in place whilst the glue dries

 

3

Glue and link panels
progressively ensuring top edges
are straight and level

4

Measure and cut a finishing panel to size with a circular, jig or hand saw

3 new

*If finishing panel would be less than half width cut both starting & finishing panels to size - see diagrams below

4

Complete the section by bonding
on an end trim

 

5

Panel remaining sections of wall in exactly the same way. Overlap panels to form internal and external corners

 

 

6

Lastly attach a finishing trim - Door architrave works best. Finepanels are primed and
ready to paint

 

Finepanels are whole primed panels not loose parts which makes them easy to handle, easy to fit and easy to finish!

 

 

 

 

 

 

 

Finepanels can usually be applied directly over the existing wall finish. All whole panels are 385mm or 585mm wide (installed) - so only the last panel of a run need be cut to size unless it would finish less than half width - 225/325 mm (Shaker 232/332mm)If so reduce the width of the starting and finishing panels to make the run symmetrical- see diagrams below and our downloadable Instructions containing more information and tips on how to plan an installation, attach panels, go round corners, cut down panels and deal with obstacles

 

installation